Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Handset Designer enables you to easily draw formwork for sloped floors.

Setting the Wall Elevations

The first step in creating create a sloped floor is to set the wall by setting Wall elevations. You will notice that each wall has four elevation values. These values correspond to the top and bottom of the wall at the beginning and end of the wall, when viewed from an elevation.

Image Removed

To set the elevation values:

1. Select the wall.

2. Click the Shape Data icon in the Handset Designer toolbar .

Image Removed

The Shape Data popup appears.

3. As necessary:

a. Click in the Top elevation at start of wall field and enter a new value.

b. Click in the Bottom elevation at start of wall field and enter a new value.

c. Click in the Top Elevation at end of wall field and enter a new value.

d. Click in the Bottom elevation at end of wall field and enter a new value.

Image Removed

Note: For measurements use ft. for feet, in. for inches or m. for meters. (Be sure to designate ft., in, or m. or you will receive an error when drawing the formwork.)

4. Click the Handset Designer tab and then click Draw Formwork.

Image Removed

Handset Designer adds formwork to the wall.

5. Click the wall again to select it.

6. As needed, click Right Elevation or Left Elevation to create the desired elevation view.

Image Removed

7. Right-click the elevation shape and select Page-# from the menu that appears.

Image Removed

Handset Designer displays the elevation with the sloped floor.

Image Removed

Panel Offset

Panels and fillers that are side by side are vertically offset from each other. Since the dado slots on the panels are at 1 ft. on center (greatest value), these offsets can only be accomplished at 1 ft.

Image Removed

...

can then view the slope by drawing Formworks and viewing the design in the left or right elevation view

Image Added

Page Tree
rootCreating a Sloped Floor