Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Formwork for sloped floors is accomplished easily in Handset Designer.


The first step in creating a sloped floor is to set the wall elevations. This is accomplished by highlighting the wall and modifying the value in your custom properties window. You'll notice that each wall has four elevation values. These correspond to the top and the bottom of the wall at the beginning and end of the wall, when viewed from an elevation.

Panel Offset

Panels and fillers that are side by side are vertically offset from each other. Since the dado slots on the panels are at 1' on center (greatest value) these offsets can only be accomplished at 1'.

Go to Previous Article: Editing Formwork          Go to Next Article: Formwork Stackup

  • No labels